It should be noted that each of the terminal applications mentioned in this blog were tested for the specific purpose of receiving with a high baud rate. Further to the recent addendum testing PCTerm, this application may replace TeraTerm in some instances. Personally, i am habitual in installing software such as RealTerm and TeraTerm on computers involved in software or hardware development. PCTerm, RealTerm and TeraTerm are noteworthy Windows based serial terminal applications which would serve hobbyists and professionals alike. The properties of the SCB UART displayed the 3Mbaud UART data rate. PSoC Creator Top Design SCB UART with 24MHz External Clock Using the UART SCB component with an external 48MHz clock resulted in the required 3Mbaud data rate. As this clock rate results in only 1.5Mbaud, the HFClock was increased to 48MHz.
Baud rate (try any one of): 9600, 230400, 115200.ĭI-1000HS-1K interface operates only at 230400 baud rate.PSoC Creator Changes for PCTerm The default HFClock 'HFClk' for the PSoC Creator UART is 24MHz.Some of them are:Īll Loadstar Sensors' devices operate with the following settings: In addition several free and/or open source serial port terminal programs are available for download on the internet. Hyperterminal is shipped with Windows XP (This can be found under ).If however you need to install the drivers on your own (you are using the device on a Linux or Mac, or writing your own software), then download and install the latest drivers the link above.Ī serial port terminal program is needed and can be used to communicate with the Loadstar Sensors' devices. The various flavors of Loadstar Sensors' software, when installed, also install the above drivers needed for this communication. Download and install the latest drivers from (Scroll down to locate the appropriate drivers for your operating system.)Īll Loadstar Sensors' interface devices use an FTDI serial-port-to-USB device to communicate with the computer through a virtual serial port.
0 kommentar(er)
